Pulling head for PE
The range of innerduct pulling heads has been developed for pulling polyethylene tubes.
It is easy to install in the tube, the ridges cling to the inside of the tube by tightening the anchor..
The standard innerduct pulling head is the most efficient way to lay polymer pipe safely. This approach is now part of good practice in this industry.
The pull head works very similarly to an expanding anchor that expands to set into masonry. Each pull head has a series of four clips connected to a ring by a tapered tail. When the ring is tightened, the tail is pulled towards the nose and the attachments spread apart.
Features:
- One piece high tensile steel ring (zinc plated components)
- Tapered profile nose
- Proven design for fasteners
- Locking bolt / Rear ring
The main components of a pull head are all manufactured under ISO 9001:2000 quality assurance standards.
For other diameters contact us (example: 180, 200, 250, etc …)
| Reference | Ø range | PE tube | Ring (mm) | Breaking (DaN) |
| GTET0003 | 24.5 – 29 | 32 | 10 | 2 900 |
| GTET0004 | 31 – 37 | 40 | 10 | 2 900 |
| GTET0005 | 39.5 – 47.5 | 50 | 10 | 2 900 |
| GTET0006 | 43 – 50 | 55 | 10 | 2 900 |
| GTET0007 | 50 – 59 | 63 | 12 | 4 800 |
| GTET0008 | 58.5 – 70 | 75 | 12 | 4 800 |
| GTET0009 | 71 – 84 | 90 | 20 | 12 000 |
| GTET0010 | 88 – 101 | 110 | 20 | 12 000 |
| GTET0011 | 99 – 110 | 125 | 20 | 12 000 |
| GTET0012 | 112 – 128 | 140 | 20 | 12 000 |
| GTET0013 | 127 – 148 | 160 | 20 | 12 000 |
| GTET0014 | 142 – 162 | 180 | 20 | 24 000 |
| GTET0015 | 158 – 180 | 200 | 22 | 24 000 |
| GTET0016 | 178 – 200 | 225 | 22 | 30 000 |
| GTET0017 | 197 – 220 | 250 | 24 | 30 000 |