The “TRMD-Elevator cable puller” accessory is intended for maintenance operations when changing elevator cables.
Once the TRMD-A assembly is mounted on the cables (one cable puller on the used cable + one cable puller on the new cable). Pulling the old cable mechanically causes the new cable to pass through the entire kinematics by pulling.
The set consists of two links connected by two braids.
The meshes are tightened (braid side) thus preventing the cable from completely crossing the mesh.
Galva references
SWL : Ssafety Working Load with safety factor: 4
Charge : Valeur correspondante au poids (du câble) compris entre le sol et la première poulie de la cinématique, ou bien la longueur de câble la plus importante en position de montage.
Please contact us for mode information.
Reference | Diameter | Breaking (daN) | LM (mm) | LN (mm) | # cable | Ø dcable (mm) | Ø loop cable (mm) | Kg |
GG1520018 | 8/13 | 700 | 2×500 | 360 | 2 | 1,75 | 0,08 |
Our technical department is available to provide any further information and to advise you on the product best adapted for your needs (breaking strength, dimensions, etc.). The above-mentioned dimensions are for reference only. Gattegno reserves the right to make changes at any time.
OUR CABLE GRIPS ARE NOT LIFTING ACCESSORIES.
Gattegno declines all responsibility in case of misuse.