Wire guide plugs

Standard shuttle

The shuttles are propelled through the ducts by compressed air. Each shuttle has an attachment ring to which a nylon or steel drawing line or a calibration mandrel can be attached.

Length capacity : 600 M

Mandrel and calibration shuttles are equipped with calibrated rings to detect any obstruction or crush in the conduct.

Standard calibration mandrel

Calibration mandrels are used to verify and qualify the inside diameters of pipes. They can be paired with standard ferrets for simultaneous calibration and routing.

Standard wire guide shutter

t consists of a buffer system to obstruct the conduct and a handle providing compressed-air.

The buffer inflates on the tube walls by turning the handle. A 7 mm steel shaft allows the cable to pass through.

Recommandations :

• Pressure Max 7 bars
• Flow Max 3500 liters

Important : Evacuate all personal from the chambers before opening the compressor

Wire guide shutter ref.	Calibration mandrel ref.	Shuttle ref.	Reference	A	B Joint length	C Seal rubber	C max.	Passage	Operculum Ø	Shuttle Mandrel
GOBT0001	GMAD0001	GFUR0001	GOBTU 25X28	205	60	60	27	L	7	28
GOBT0002	GMAD0002	GFUR0003	GOBTU 30X33	200	60	60	32	C – L	7	33
GOBT0003	GMAD0003	GFUR0004	GOBTU 42X45	300	67	67	45	C – L	7	45
GACD0004	GMAD0012	GFUR0005	GOBTU 47X50	300	67	67	50	C – L	7	50
GOBT0004	GMAD0004	GFUR0006	GOBTU 55X60	205	67	67	60	L	7	60
GOBT0005	GMAD0005	GFUR0007	GOBTU 75X80	200	67	67	78	C – L	7	80
GOBT0006	GMAD0006	GFUR0008	GOBTU 96X100	300	67	67	102	C – L	7	100
GOBT0035	nous consulter	GFUR0019	GOBTU 103X110	286	67	67	108	L	12	110

L= Lateral C= Central