Pulling Standard cable grip – Sleeve model

Ideal for joining two ropes (except crane and overhead hoist ropes) and providing continuity, especially when replacing an old rope with a new rope.

You will find all the specifications in the table below.

Galva & Inox references

Standard pulling cable grip sleeve.

Gattegno Standard pulling cable grip sleeve.
Standard pulling cable grip sleeve for electric cable installation
cable grip sleeve by Gattegno

Galva references

ReferenceDiameterBreaking
(daN)
LM
(mm)
# cableØ cable
(mm)
Kg
G13300145/879040020,750,03
G13300038/15110045021,050,05
G133000115/25250065021,20,13
G133000225/45380080031,20,24
G133002045/60780085031,50,58
G133000960/8089001000220,80
G133001980/1008900915220,80
G1330008100/14016900166532,252,38

Inox references

ReferenceDiameterBreaking
(daN)
LM
(mm)
# cableØ cable
(mm)
Kg
G13300355/839040010,750,03
G13300128/15130045021,050,05
G133001115/25260065021,20,13
G133001025/45500079531,50,24
G133002145/60670090031,50,58
G133004660/8075001000220,80
G133004780/10075001000220,80
G1330007100/14015200166532,252,38

Our technical department is available to provide any further information and to advise you on the product best adapted for your needs (breaking strength, dimensions, etc.). The above-mentioned dimensions are for reference only. Gattegno reserves the right to make changes at any time.

OUR CABLE GRIPS ARE NOT LIFTING ACCESSORIES.
Gattegno declines all responsibility in case of misuse.